OpenMP and STL

Use this forum to discuss the book: Using OpenMP - Portable Shared Memory Parallel Programming, by Barbara Chapman, Gabriele Jost and Ruud van der Pas Read the viewtopic.php?f=8&t=465 for book info and to download the examples. Post your feedback about the book and examples to this forum

OpenMP and STL

Postby sajis997 » Mon Dec 31, 2012 3:22 am

Hello forum,

I am having problem(segmentation fault) with the following code snippet:

Code: Select all

   //create a pointer to the hitpoint
   HitPoint hitPoint;

   //loop over all the pixels in the image
#pragma omp parallel for schedule(dynamic,1), private(hitPoint)
   for(int y = 0; y < height; ++y)
      for(int x = 0; x < width; ++x)
    hitPoint = traceAndCreateHitPoint(x,y);

    //store the hit point inside the vector

      #pragma omp critical
      // Print progress approximately every 5%.
      if ((y+1) % (height/20) == 0 || (y+1) == height)
         std::cout << (100*(y+1)/height) << "% done" << std::endl;     

Is there any issue that need to be resolved when using openmp with STL. If i comment the STL command , the code runs fine.


Re: OpenMP and STL

Postby MarkB » Mon Jan 07, 2013 8:15 am

None of the STL containers are guaranteed safe to access using multiple threads in this way. You need to make sure only one thread at a time calls push_back(): putting the call in a critical section should work, though this may not be the most optimal solution.
Posts: 797
Joined: Thu Jan 08, 2009 10:12 am
Location: EPCC, University of Edinburgh

Return to Using OpenMP - The Book and Examples

Who is online

Users browsing this forum: No registered users and 5 guests